cement plaster (stucco) wall claddings as specified by ASTM stucco industry standards. Standards ASTM C and ASTM C were carefully researched by. Lathing and furring accessory and fastener installation requirements remain in C as well. This standard does not replace ASTM C violation of the building code IBC and FBC referenced ASTM. C, which establishes the requirements for stucco applied over a metal plaster base a.k.a. lath.
|Published (Last):||2 February 2009|
|PDF File Size:||15.49 Mb|
|ePub File Size:||2.30 Mb|
|Price:||Free* [*Free Regsitration Required]|
Lathing and furring accessory and fastener installation requirements remain in C as well.
Since its formation inthe ASTM C11 Stucco Work Group has worked toward reconciling inconsistencies in current standards and creating new standards that reinforce consistency in the stucco industry. Link to Active This link will always route to the current Active version of the standard.
The following materials shall be used: This specification covers the installation of lathing and furring to receive interior and exterior Portland cement-based plaster. Little can be reached at c. The new standard is available and ready at astm.
Hangers and cold-rolled channel main runner shall conform to the allowable spacing and spans, respectively. This page can be found at http: ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete c10633 up to date.
WallsandCeilings – September 2018
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided astn part of the standard. This specification contains the minimum requirements for lathing and furring accessories, fasteners, etc.
Looking forward, the SWG is now developing requirements that will fill the significant needs of building owners, designers, and craftsmen in the stucco industry for the use of continuous insulation and drainage, addressing other important stucco industry topics. With a copyright, the document is not f1063 be duplicated without ASTM permission.
It is informational only atsm not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
This new standard will be useful to a wide spectrum of stakeholders, including building owners, specifiers, engineers, architects, manufacturers, and applicators throughout the industry. The standard is listed under C The Stucco Work Group meets virtually via webinar and review items that have been proposed, make suggested changes and then develop those into ballot-worthy items for the ASTM committee to vote on a semi-annual basis.
The following methods are discussed: These requirements do not by default define a unit of work or assign responsibility for contractual purposes, which is the purview of a contract or contracts made between contracting entities.
Work Item s – proposed revisions of this standard.
A New ASTM For Plaster Accessories
He has 20 years of experience in new product development and technical support, and has also played an integral role in helping shape industry standards for lathing and plastering, as well as installation of masonry stone veneer. These were included to provide basic guidance on the shape or appearance of the accessories; both old and new. Historical Version s – view previous versions of standard. Little is senior product manager at ClarkDietrich Building Systems.
This abstract is a brief summary of the referenced standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.